BMW Generic ABS Removal Instructions

BMW 540 ,528 ,740 REMOVAL & INSTALLATION INSTRUCTIONS


bmw-generic-abs-removal-instructions-page-1-image-0001-fixed.jpg

 

Release lock on plug connection (1) in direction (2). Detach plug connection (1) in
direction (3) vertically toward top.

 

Installation: Position plug connection (1) vertically on control module in order to avoid damaging pins

 

bmw-generic-abs-removal-instructions-page-2-image-0001.jpg

 

Release screws (1) and detach control module (2) from hydraulic unit.
Installation:
Replace screws (1).

 

bmw-generic-abs-removal-instructions-page-3-image-0001.jpg

 

Check sealing face (1) for damage (visual inspection).
Clean sealing face (1); do not use any sharp-edged tools or aggressive cleaning agents
here. Check contact lugs (2) for corrosion or damage.
Installation:
Replace hydraulic unit if sealing surface (1) or contact lugs (2) is/are damaged.

 

bmw-generic-abs-removal-instructions-page-4-image-0001-fixed.jpg

 

Carefully push control module (1) onto hydraulic unit (2).
Make sure that solenoid coils do not tilt.

 

bmw-generic-abs-removal-instructions-page-4-image-0002.jpg

 

Housing edge of control module (1) must slide over extension on hydraulic unit (2).

 

bmw-generic-abs-removal-instructions-page-5-image-0001.jpg

 

Press control module onto hydraulic unit and screw in screws (1 +2) evenly (do not
tighten down) until control module is resting evenly on hydraulic unit.
Insert screws (1-6), do not tighten down yet.
Tighten down screws (1-6) in specified sequence with torque wrench.

 

 

 

Download a pdf of these instructions here.

Return to BMW Technical Instructions

Return to Knowledge Base