2000-2004 Corvette Climate Control Removal Instructions
REMOVAL PROCEDURE:
1. Disconnect the negative battery cable.
2. Remove the I/P accessory trim plate.
3. Remove the HVAC control head retaining screws.
4. Pull the control head out from the I/P center support bracket to access the electricalconnector
5. Disconnect the electrical connector from the control head.
6. Remove the control head from the vehicle.
INSTALLATION PROCEDURE:
1. Connect the electrical connector to the HVAC control head.
2. Install the control head to the I/P center support bracket. NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the HVAC control head retaining screws. Tighten Tighten the HVAC control head retaining screws to 1.9 N.m (17 lb in) .
4. Install the I/P accessory trim plate.
5. Connect the negative battery cable. Tighten Tighten the negative battery cable bolt to 15 N.m (11 lb in) .
6. Program the transmitters. Refer to Transmitter Programming/Synchronization in keyless Entry.
Download a pdf of these instructions here