1999-2004 Volvo V70 Climate Controller Removal Instructions
Dashboard Environment Panel (including Climate Control Module (CCM))
Replacing dashboard environment panel
-Ignition off.
-Remove the key.
NOTE:
-The key must be removed to ensure that the ignition is not switched on by mistake.
-After the key has been removed: Wait 3 minutes before starting work.
-has a pen holder above the gear selector panel. Remove it.
-Remove the panel (1) above the gear selector.
-Carefully pry off at the back using a weatherstrip tool.
Remove:
- the two screws (2) on the lower edge of the panel
- the panel (3).
NOTE: The radio component and the dashboard environment panel are complementary and are mounted at the join with hooked mountings.
HINT: To facilitate removal: Angle the dashboard environmentpanel outwards so that it is possible to insert a couple of fingers between the center console and the dashboard environment panel.
Pull the dashboard environment panel downwards at the same angle.
HINT: The dashboard environment panel is correctly secured. Force is required to remove it.
-connectors.
Lift out the panel.
Install:
In reverse order.
NOTE: If any of the outer hooks break off, this must be rectified.
Tape the 3.5 mm thick component measuring 20 X 20 mm to the reverse of the dashboard environment panel. Use double-sided adhesive tape.
Fix the other side of the piece with double-sided adhesive tape so that there is a solid anchorage when reinstalling against the center console.
Download a pdf of these instructions here